V-tech PC6 Manual User Manual download pdf

1. Introduction:

The PC6 is a power comb unit,which is designed for DT 2

wire system to supply power for outdoor station, indoor

monitor and other accessories. It can work both as a nor-

mal power comb and auxiliary power comb. The features

are as follows:

• Universal AC input/full range

• Multi protection: short circuit, overload, over voltage

• Integrated with DT-DPS(power separator), Additional

DT-DPS is not needed.

• Support up to 4~8 monitors(depend on models)

• DIN rail mounting

2. Terminal Description:

4. Wiring:

Open the AC cover:

1. push the cover bottom

towards the center with

your hand;

2. turn over and pull it out.

After connect the AC cable,

it is suggested to close the cover.

PC6 Power Comb Instructions

5. Specication:

Input Voltage: 100~240Vac

Input Frequency: 50~60Hz

Rated Output Voltage: DC 28V+2V

Rated Output Current: 1.5A

Working Temperature: -10

C~50

SW Port Input Voltage: Max.230Vac, 2A

Dimension: 140*90*60mm

3. Mounting:

Step1: Mount the din rail to the wall with screws ;

Step2: Pull down the mounting buckle,then hang the

unit on din rail.

N: AC input.

L: AC input.

SW: switch terminal. It can extend to connect light or

lock.

LED: power indicator,always on when plug in power.

CN2: normal power comb or auxiliary power comb se-

lection terminal. Please refer to part 4.

CN1: bus control terminal.

BUS(IM): indoor monitor connection terminal.

BUS(DS): door station connection terminal.

Note:

1. the AC cable is not included in the package, it must

comply with requirements of dierent country.

2. If N,SW terminal is connected light or lock, CN1

terminal must connect SC6 controller to support this

function.

3. pin1&2 should be short-circuited with a C3-3P

line(included in the package) if the unit work as a nor-

mal power comb. But if it work as a auxiliary power

comb, pin 1&2 should be taken o.

6. Warning:

- The unit can only be used in DT 2 wire products sup-

plied by our company.

- Don’t connect the unit with any non-specified power

source. Fire or electric shock could result.

- Don’t dismantle or alter the unit. Fire or electric shock

could result.

- The unit must be installed and wired by a qualified

technician.

- Keep the unit away from water or any other liquid. Fire

or electric shock could result.

We reserve the right to modify the specication in this manual at any time without notice.

Din rail

Mounting Buckle

N N L SW

LED

CN1CN2

1 2 3

BUS(IM) BUS(DS)

N N L SW

AC~

connect to light/lock

CN1CN2

1 2 3

BUS(IM)

Connect to monitor Connect to door staiton

BUS(DS)

PC6 Power Comb Instructions 1

Summary of Contents

Page 1 - PC6 Power Comb Instructions

1. Introduction:The PC6 is a power comb unit,which is designed for DT 2 wire system to supply power for outdoor station, indoor monitor and other acce

Comments to this Manuals

No comments

V-tech PC6 Manual User Manual

Browse online or download User Manual for Accessories for electrical V-tech PC6 Manual. V-Tech PC6 Manual User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Accessories for electrical V-tech PC6 Manual